To perform the Densify operation on all raster maps in a map list, type one of the following expressions on the command line of the Main window:
|
OUTMAPLIST |
= |
MapListApplic(InputMapListName, MapDensify(##, factor, nearestneighbour)) |
|
OUTMAPLIST |
= |
MapListApplic(InputMapListName, MapDensify(##, factor, bilinear)) |
|
OUTMAPLIST |
= |
MapListApplic(InputMapListName, MapDensify(##, factor, bicubic)) |
where:
|
OUTMAPLIST |
is the name of the output map list map; all output raster maps will be created when the map list is opened, the raster maps will obtain the same name as the map list followed by _1, _2, _3, etc. |
|
MapListApplic |
is the command to start an operation on all raster maps in a map list. |
|
InputMapListName |
is the name of the input map list which contains all raster maps on which the operation should be performed. |
|
MapDensify |
is the command to start the Densify operation. |
|
## |
is an obligatory parameter in map list expressions; it indicates the individual raster maps in the input map list. |
|
factor |
|
|
nearestneighbour |
|
|
bilinear |
|
|
bicubic |
When the definition symbol = is used, a dependent output map list is created. When the map list is opened and thus calculated, the dependent output raster maps will be defined and calculated.
When the assignment symbol := is used, the output raster maps will be defined and calculated, then the dependency links of the output raster maps will be broken.
See also: